Гидронасос 708-1L-00650 для экскаватора Komatsu PC130-7 PC130-7K

1. Product Identification & Compatibility
This pump is designed for a precise fit and immediate performance restoration.

Primary OEM Part Number: 708-1L-00650

Interchangeable/Superseded Numbers: 708-1L-00651, 708-1L-00540, 708-1L-00440

Machine Fitment: * Komatsu PC130-7

Komatsu PC130-7K

Condition: Original Brand New (Genuine Komatsu / HPV series)

2. Technical Advantages of the Original Pump
The PC130-7 is a high-production 13-ton machine. Using an Original Brand pump is critical for several reasons:

HPV Series Precision: Original pumps utilize the high-efficiency HPV piston architecture, ensuring maximum hydraulic horsepower is converted from the engine without excessive heat generation.

Pre-Calibrated Regulators: The LS (Load Sensing) and PC (Pressure Compensation) valves are factory-tuned to the PC130-7's specific engine torque curve. This ensures the machine doesn't "bog down" during heavy trenching or lifting.

Enhanced Service Life: Original units feature proprietary surface treatments on the cylinder blocks and valve plates to resist cavitation and wear under the high-pressure cycles (up to 34.3 MPa) typical of the Dash-7 series.

3. Critical Installation Protocol
To protect the warranty and longevity of a genuine 708-1L-00650, follow these expert steps:

Case Priming: MANDATORY. Fill the pump case with clean hydraulic oil through the highest drain port before starting the engine. A "dry start" will destroy the internal piston shoes in seconds.

System Decontamination: If the previous pump failed mechanically, you must flush the hydraulic tank, lines, and oil cooler. Residual metal fragments are the most common cause of failure in new pumps.

Filtration & Oil: Always replace the suction strainer and return filter with genuine Komatsu elements. Use high-quality ISO VG46 anti-wear hydraulic oil.

Air Bleeding: After installation, run at low idle for 10 minutes, cycling each cylinder slowly to its full stroke to purge air from the system.

4. Logistics & Support
Packaging: Shipped in a reinforced, moisture-protected export wooden crate.

Fitment Guarantee: We verify the input shaft spline and mounting pilot against your Machine Serial Number to ensure 100% accuracy.

Shipping: Global express via DHL, FedEx, or UPS, typically arriving in 3 to 7 business days.

Ordering Information
To provide an accurate quote and confirm stock for a Genuine 708-1L-00650, please provide:

Your Machine Serial Number.

Your delivery location.

Would you like a formal quote for this Original Brand New unit, or do you need technical assistance with your current hydraulic troubleshooting?